- 1/2 HP, 115 Volt, single-phase, 2-wire
- Superior performance
- Stainless steel and composite construction
- Exclusive industry dry-run capability
- Enclosed and self-lubricated Nylatron® shaft-bearing resists
wear from sand
- Serviceable fiberglass reinforced thermoplastic intake screen
Proven “Floating Impeller”
Staging System – Incorporates
1st-in-class performance, sand
handling and thrust management
staging system with the industry
exclusive “dry-run” design element.
Reinforced engineered composites
and stainless steel, offering high
resistance to corrosion and abrasion.
Discharge – Tested-tough, fiberglass-reinforced
thermoplastic, with proven
internal check valve. Large wrench
flats and rope hole.
Shell – 300-grade stainless steel
pump shell offers high corrosion
Shaft – Hexagonal 3/8″, 300-grade
stainless steel pump shaft; offers
generous impeller drive surfaces.
Shaft Bearing – Exclusive self-lubricating
Nylatron bearing resists
wear surface from sand.
Motor Bracket – Tested-tough,
incorporates an integral suction
1-year limited warranty
HORSEPOWER: 1/2 HP
VOLTAGE: 115 volts, 60 Hz
AMP DRAW: 10.5 amps at full load
SHELL: Stainless steel
DISCHARGE: 1-1/4″ NPT, Fiberglass-reinforced thermoplastic
DISCHARGE BEARING: Nylatron®
IMPELLERS: Delrin® (5 stages)
DIFFUSERS: Polycarbonate (5 stages)
SUCTION CAPS: Polycarbonate with stainless steel wear ring
THRUST PADS: Proprietary spec.
SHAFT AND COUPLING: Stainless steel 300 grade
INTAKE: Fiberglass-reinforced thermoplastic
INTAKE SCREEN: Polypropylene
POWER CORD: 300 Volt “SOOW” jacketed 10′ leads, 115 Volt, 2-wire with ground